Sensor problems
Look up the message you see and follow the recommended action.
During install
Section titled “During install”| Message | Action |
|---|---|
| No sensor nearby. | Wake the sensor again: tap the cap of an A6 twice, or move a Mini by hand. Check that the light blinks. |
| Sensor not found. Check the number on the label. | Re-enter the serial number, or scan the QR code. |
| Wrong key. Check the label. | Re-enter the key printed below the serial number. |
| The app has no Bluetooth access. | Allow Bluetooth for the Argos app in the phone settings. |
| Connection to the sensor lost. | Move closer to the sensor and wake it again. |
| The machine seems stopped. | No action needed. The installation is accepted while the machine is stopped. |
| Your account cannot install sensors. | Ask your administrator for a role with this permission. |
Wi-Fi test (A6)
Section titled “Wi-Fi test (A6)”During installation the A6 tests the plant Wi-Fi connection. If a stage fails, the app shows one of these messages:
| Message | Action |
|---|---|
| The sensor cannot find the network. | Check the network name. The network must be 2.4 GHz. Move the access point closer if needed. |
| Wrong password. | Re-enter the Wi-Fi password. |
| The network gave the sensor no address. | Ask IT to enable DHCP. |
| The network does not resolve names. | Ask IT to check DNS. |
| The network has no internet access. | Ask IT to allow internet access for the sensor. |
| The network blocks port 443. | Ask IT to allow outbound traffic on port 443. |
| The server refused the sensor. | Contact support. |
If no working Wi-Fi is available, choose Only through the app instead.
After install
Section titled “After install”| Shown in the web app | Action |
|---|---|
| Offline or No data | Check the gateway lights or the Wi-Fi connection. A sensor that uses a gateway needs one within range. |
| Low battery (Bateria baixa) | The battery is below 20 %. Contact your Argos representative. |
| Weak signal (Sinal fraco) | Move the gateway closer or higher, and keep it out of metal enclosures. |
| Pending configuration | Go to the sensor with the phone app and tap Apply settings. |