The gateway has three status lights: green for power, red for the network connection and yellow for sensor activity.
| Light |
Meaning |
| On |
The gateway is powered. |
| Off |
No power. Check the power supply and the outlet. |
| Light |
Meaning |
Action |
| On |
Online. The light turns off briefly with each upload. |
None. |
| Slow blink |
Connecting to the network. |
Wait up to one minute. |
| Two short blinks, then a pause |
Connected to the network, but the Argos server is unreachable. |
Ask IT to allow port 443. See Gateway problems. |
| Three short blinks, then a pause |
Not yet registered. |
Register the gateway. |
| Off |
No network configured. |
Connect it to the network. |
| Light |
Meaning |
Action |
| On |
Sensors are in range. The light turns off briefly each time a sensor transmits. |
None. |
| Slow blink |
Downloading data from a sensor. |
None. |
| Fast blink |
Fault in the sensor radio. |
Restart the gateway. If the fault persists, contact support. |
| Off |
No sensor received in the last 30 minutes. |
Check that sensors are installed and within range. |
| Lights |
Meaning |
| Alternating, slow |
Setup mode is open and a phone can connect. |
| Alternating, fast |
A phone is connected for setup. |
| Blinking slowly together |
Firmware update in progress. Do not disconnect the power. |
| Blinking fast together |
Localizar (Locate) was triggered in the app, or the button is being held for a factory reset. |
| Red off, yellow two blinks |
Safe mode after a failed update. Contact support. |
| Both on briefly |
Normal during start-up and immediately after a factory reset. |
To identify one gateway among several, open it in the phone app or the web app and select Localizar (Locate). Its red and yellow lights blink rapidly for 30 seconds.