Button and reset
The gateway has a single button, located between the green light and the power socket.
| Press | Result |
|---|---|
| Short press, under 2 seconds | Opens setup mode for 10 minutes so a phone can connect. |
| Hold for 5 seconds | Warning: the red and yellow lights blink rapidly . Release now to cancel. |
| Hold for 10 seconds | Factory reset. |
Open setup
Section titled “Open setup”Press the button briefly. The red and yellow lights alternate while setup mode is open, for up to 10 minutes.
Setup mode also opens automatically when the gateway has never been configured, or when it has had no network connection for 10 minutes.
Factory reset
Section titled “Factory reset”Use a factory reset when moving the gateway to a different network, or when other troubleshooting steps have not helped.
-
Press and hold the button.
-
After 5 seconds both lights start blinking rapidly. Keep holding.
-
At 10 seconds both lights stay on briefly. Release the button.
-
The gateway restarts.
-
Configure the network connection again. See Set up a gateway.